Podręcznik pilota i instrukcja obsługi Dewalt Dwd522

Subskrybuj nasze sieci społecznościowe, aby być na bieżąco z najnowszymi aktualizacjami!

Komentarz

I rebuilt my deck and my grandparents' deck with my dewalt impact that I got in 2019. Just noticed early this fall while on my grandparents' deck that it had a little grease seeping out of the case seams and was getting hot. Just decided to crack into it this evening. Looking forward to cleaning it up and re-greasing. Always looking at ways to make my tools last. Thanks for the video!

If you coat the o-ring with a light layer of the grease it helps them stay stuck where you put them and helps them from pinching in my experience from rebuilding dirtbike motors. Might not apply here just thought I’d share

Please note rhat there is a different kind of grease to each part. The bearing, uses bearing grease (kind of Yellow). The gear uses graphite (Grey) or multi purpose grease (Red). And the seal uses seal grease which don't harm the rubber (Also Yellow). Wonderful video!

Most companies unfortunately use a cheap inferior grease when they build their tools.

While I think it is ridiculous one are not allowed to service your own tools without voiding the warranty. I do think you might have mentioned that cutting those stickers voids any warranty you might still have on the tool. Thank you for the clear explanation on how to service these tools. I'm going to see if I can breath some extra life into mine.

I was pumped to learn how to regrease my impacts until what you said at

Great. I'm gonna do this but re-greasing is something that 99% of user will never consider doing.

Can we use general purpose grease, or is it too thick?

also the bearing can use a pin to pop seal race cover out and pack grease in there because its a Key area they skimp on often

great video! super informative

I have replace the grease about 1 to 3 times and I have seen the power tools results that make the tool work all the way

Thanks for sharing. Liked, subscribed and commented. Now to see what might be bad on my DCF899H and what all maintenance I'll need to perform. I'll link your video in my description as well.

I take the same care with self tapping screws. Good job!!!

Why don’t you remove the old grease. It kind of looked contaminated with small metal flakes. What about removing the end cap off of the bearings and greasing those?

Finally a understandable video with a English speaking person .. lol seriously man this isnt even the type of drill i have or need info about but it will do for now

What grease do you recommend? I've heard that the Dewalt grease is a moly based grease.

Thanks for this great video!

Awesome vid. Liked and subscribed. I might ask you for some guidance sometimes If that’s okay ? My first time servicing a power tool.

Any idea what would cause the front silver end to loosen up? I can grab that part and shake it a little bit. My DCF886 is a few years old but hasn't really been used extensively.

I used moly grease. Sound is quite better. Since it extreme slippery, it like to leak out at socket, these reason have to considering . . . . Thump up and like from Thailand.

.

Zostaw komentarz

#0